It is typically made of stainless steel and has a capacity of five gallons. What can you make with a beer keg?Ī beer keg is a container that is used to store and dispense beer. If everything is working properly, you can now start brewing beer or distilling spirits. Make sure that the keg is full of water before you do this, as it can be dangerous to have a gas leak. Once everything is attached, you can test the boiler by turning on the burner. The regulator will attach to the burner, and the gas line will attach to the regulator. The last step is to attach the regulator and gas line. This can be done with a few screws or by using a metal band. Next, you will need to attach the burner to the keg. You will want to make sure that the hole is in a good spot for the burner, so it is important to measure before you drill. The first step is to drill a 2 inch hole in the side of the keg. To make a keg boiler, you will need the following supplies: There are many ways to make a keg boiler, but we will be discussing the most popular and easiest way. The alcohol will condense and travel back down the pipe and into the keg. The alcohol will be distilled by the difference in temperature between the pot and the keg. The final step is to distill the alcohol. The thermometer will be used to monitor the temperature of the pot. The valve will be used to control the flow of the alcohol. The alcohol will evaporate and travel up the pipe and into the keg. The next step is to heat the pot on the stove. See also How Many Beers Are In A Four Loko Place the beer keg in a cold water bath to cool it down. Remove the beer keg from the pot of boiling water.ġ1. Allow the alcohol to distill into the hose.ġ0. Place the beer keg in the pot of boiling water.ĩ. Put a pot of water on the stove and bring it to a boil.Ĩ. Screw the cap onto the top of the beer keg.ħ. Attach the funnel to the hole in the side of the beer keg.Ħ. The hole should be large enough for the socket wrench to fit through.Ĥ. Cut a hole in the bottom of the beer keg with the hacksaw. Cut the top off the beer keg with the jigsaw.ģ. The hole should be large enough for the funnel to fit through.Ģ. Drill a hole in the side of the beer keg near the bottom. In this article, we will show you how to build a pot still using a beer keg.ġ. The most common type of still is the pot still, which is simple and easy to make. A still is a device used to distill alcohol from a fermented mixture. It can be made in a variety of ways, but one common method is to use a still. Moonshine is a strong alcoholic drink made from corn, sugar, and yeast.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |